Ero sivun ”Viscous APRS Digipeater.en” versioiden välillä

Radioamatööriwikistä
Siirry navigaatioon Siirry hakuun
p (Oh6va siirsi sivun Viscous APRS Digipeater uudelle nimelle Viscous APRS Digipeater.en: -> .en)
p (luokittelu)
 
Rivi 30: Rivi 30:


[[Image:ViscousDigipeaterTxEffect.png]]
[[Image:ViscousDigipeaterTxEffect.png]]
[[Luokka:APRS]][[Luokka:English Page]]
[[Luokka:APRS]]
[[Luokka:English]]

Nykyinen versio 11. kesäkuuta 2021 kello 13.42

Viscous APRS Digipeater is a modification of APRS Digipeater, which puts all packets heard from radio channel into a short term probation delay hold (4-8 seconds,) and checks to see, how many copies of that same packet (per APRS packet duplicate detection algorithm) will be heard during that interval.

If a packet is heard only once, it will then be processed like normal digipeater request. If a packet is heard more than once, it is silently forgotten.

At present (October 2009) only one software is able to do this: Aprx

With fresh Aprx v2, the necessary configuration is like follows:

 mycall  OH2MQK-1
 <interface>
    serial-device /dev/ttyS0 19200 8n1 KISS
    callsign  $mycall
    tx-ok     true
 </interface>
 <digipeater>
    transmit $mycall
    <source>
        source         $mycall
        relay-type     digipeat
        viscous-delay  5
    </source>
 </digipeater>

Graphs below show effect of enabling the viscous-delay 5 on digipeater configuration.

  • Top graph is number of packets heard from radio.
  • Mid graph is packets rejected by APRS Rx-iGate function (and unrelated to this topic)
  • Bottom graph shows counts of packets transmitted by the digipeater subsystem.
    • Most notable is that this added viscosity to digipeater does reduce transmissions by 80 to 95 percent.

ViscousDigipeaterTxEffect.png